PCV Cell Counting Tubes
- Send to friend
- Customers also bought
- Customer feedback
PCV Tubes from TPP allow researchers to count the number of cells in their sample without wasting time with hemocytometers. Traditionallly, researchers sit under a microscope and manually count cells using an unprecise way of measuring cells. PCV Tubes require 1mL of sample, spin in a centrifuge for mere minutes, and offer far more accuracy than hemocytometers. Light Labs has one particular success story with our PCV Tubes: one customer who processes fifty samples, in a day that involves a big experiment, saved over two hours on cell counting alone. So call or email us about getting samples of our PCV tubes and try them for yourself.
What is PCV?
PCV or Packed Cell Volume describes the volume that is occupied by a cell pellet after centrifugation. A PCV of 0.1% means that 1 ml of cell pellet is expected per 1 liter of cell culture, respectively 1µl per 1 ml sample (1 µl cell pellet = 1 mg wet biomass).
What is the unit of the novel PCV tubes?
The volume of the cell pellet is measured in µl. This value can be directly read from the calibrated capillary. It depends on the cell density and the sample volume. Dividing it by the sample volume yields % PCV. For example reading 4 µl for a 400 µl sample corresponds to 1% PCV (4µl /400µl = 1 %). The % PCV value linearly correlates with the cell density.
Should the % PCV be converted into a cell number per ml?
The % PCV is an absolute value that can be measured rapidly and without the need of calibration curves or conversion factors. The % PCV value is proportional to the cell density: a cell culture of 1% PCV yields after a 10-fold dilution a density of 1% PCV and cell growth results in an increase (see figure 1). Thus the % PCV value can be used the same way as cell number and a conversion into cell number is not necessary. For certain studies (e. g. measuring specific consumption rates, working with cell extracts etc.) % PCV might even be the better choice than cell number, which is sensitive to the actual size of the cells. However, sometimes a conversion into cell number is convenient (see below).
Are dilutions needed?
No dilutions are necessary! If the packed cell volume exceeds the capacity of the capillary (e.g. for a 1 ml sample this is the case if the % PCV is higher than 0.5%), then the sample volume has to be reduced. Smaller sample volumes are used to analyze cultures with higher cell densities without an upper limitation.
How is PCV converted into a cell density (cells per ml)?
Even if % PCV can be used as an independent parameter, it is in most cases helpful to convert it into a cell density. The conversion can be done by a simple multiplication once the number of cells that fit into 1µl of cell pellet is known. There are two options to figure out this value.
- Vertical Gel Box$549.00
- Upright Freezer Drawer Racks for 1mL Blood Sample Tubes (Capacity: 324 Tubes)$211.75
- Bottle Top Filters, PES$109.00
- Adventurer™ Pro Precision Balances -- With InCal$910.00
- So-Low -80C Ultra Low Chest Freezer, 27 Cubic Foot$10,944.00
- Pipette Starter Kit$549.00
- Labnet Micro Array Slide Spinner$395.90
- Tacky Traxx, Blue, 24''x 36'', 30 Sheets/Mat, 4 Mats/Case$47.50
- Tacky Traxx, Grey, 26'' x 45'', 60 Sheets/Mat, 4 Mats/Case$115.99